Mold Removal and Mold Remediation

Mold Removal

Mold removal can be dangerous, especially when dealing with black mold. Mold remediation stops mold growth and allows us to begin mold removal. This process starts by preventing further contamination. We set up a complete containment zone using a plastic decontamination barrier with negative air pressure to prevent the spread of mold spores. After an area is fully contained, we do a visual inspection. Upon visual inspection, 18 inches is measured from the edge of visible mold and all material within that radius is removed.
Mold Removal and Mold Remediation

Mold Remediation

After all moldy material is removed, we seal off all the cracks and crevices that we cannot actively clean. Once all mold has been removed and the air is cleaned through a HEPA filter, we have a 3rd party industrial hygienists measure for mold spores outside the area and compare it to a second measurement within the previously affected area. A passing score is to have fewer mold spores inside than outside. At Raysco, Inc., we strive for zero spores or a non-detected result after the mold removal and restoration, to ensure your home is safe and clean. Although this is not guaranteed, we achieve zero spores about 80% of the time and we are working very hard to get that other 20%. To achieve a zero-spore result, we at Raysco, Inc take the proper steps to remove all the mold by utilizing 18" or greater extended cuts, proper disposal of contaminated materials, and thorough cleaning of the entire area. Without these proper steps, mold will eventually grow back.

Moldy Air Ducts

Air duct cleaning and maintenance is URGENT if you notice any kind of mold growing in any area of your house. The biggest issue with microbials is that they grow by releasing spores into the air. When those spores land on a wet surface, they begin to grow and colonize that area as well. It is important to note that insulated air ducts are more susceptible to getting wet causing mold to grow quite easily and spread throughout the structure. If you have witnessed mold or have insulated air ducts, it is important to regularly clean your air ducts.

For more information, check out our Air Duct Cleaning page.


After removal, remediation, and air scrubbing are complete, it is time to put everything back the way it was. Raysco, Inc. has partnered with AAMCO Construction for all your restoration needs. They are fully licensed and bonded for your protection.

Mold Removal Cost

Mold removal pricing is based on a visual inspection during a site visit to determine the extent of work required. Mold remediation is best done with a pre-inspection which will clearly outline the scope of work needing to be done. We whole heartedly recommend Nevada Mold Testing for your pre and post inspections. Raysco, Inc. would be honored to arrange all your mold inspections, mold removal, mold remediation, and complete restoration.

Request service from one of our floor care experts.